Flexo Mounting System
Flexo Mounting System

Our new patented Flexo Mounting System has been created to attractively terminate applications with a secure mountable end. This new Mounting System is engineered to work with Flexo PET 1 1/2” & 1 3/4”, and with Flexo Clean Cut 1 1/2”. The installer friendly part clamps securely onto the sleeve without attaching to your wiring for ideal strain relief. The two piece construction removes any limitations in size created by large connectors and preserves the sleeving’s expandability. Automotive grade glass filled nylon construction is suitable for a variety of applications.

Before & After

Flexo Mounting System
Flexo Mounting System

A few minutes of time for installation, without any specialized tools, results in a strong, neat and long lasting assembly that completely hides the wire bundle and allows free access to the bundle for removal or addition of additional wires.

Flexo-Mounting System
Flexo Mounting System

Single Locking Collar Set
5 Pack Locking Collar Set
Wall Plate Only (includes 2 color matched screws)
Finishing Pack: 1 Locking Collar Set & 1 Wall Plate

Flexo Mounting System wall plates are available in Black, White and Beige to match any decor. All hidden parts are Black only.

FMS1.50FL
FMS1.50FL5
FMP1.50PLATE
FMS1.50FK

Installation Instructions

Flexo Mounting System

STEP 1

Install the sleeving over your wire bundle. Try to closely match the sleeving diameter to your bundle diameter so the bundle is fairly tightly managed. Leave about 2” of additional length to put through to the other side of the finished assembly.

Flexo Mounting System
Flexo Mounting System

STEP 2

Open the metal retaining ring and slide it over your bundle. Install the ring INSIDE of the sleeving so that the registration teeth protrude through the sleeving.

Flexo Mounting System

STEP 3

Take one of the locking collar halves (it doesn't matter which one... they're identical) and place it over the teeth on the retaining ring. It is important that the teeth of the retaining ring protrude into the appropriate holes in the locking collar. Hold it in place while you align the other half of the locking collar to the locking tabs on the ends of both halves. Squeeze the 2 halves together until both ends snap and lock together.

Flexo Mounting System
Flexo Mounting System

STEP 4

Smooth out the sleeving to allow the wall plate to easily slide up the length of the cable bundle. Slide the wall plate onto the assembly so that the side that faces the wall is against the locking collar. Snap the locking collar over the registration pins on the inside of the wall plate. Screw the wall plate into the workbox with the included color matched screws.

How To Install Flexo Mounting System
How To Install the Flexo Mounting System

Download this instruction sheet to learn how to install the Flexo Mounting System and create a secure and attractively managed through-wall cable bundle. Just click on the thumbnail to open the .pdf instruction sheet.


104 Demarest Road Sparta, NJ 07871
9:00am - 5:30pm EST
973-300-9242
973-300-9409

Copyright © 2016 Techflex, Inc. All Rights Reserved. | Terms of Use | Sitemap | Contact Us |
Translate This Page